Resin Epoxy Keychain Magnet Hole Round 6 cm - A1

 Epoxy Resin Keychain Drilled Round 6 cm A-1

Epoxy resin silicone injection molds are heat-resistant and easily removable, meaning they can be taken out after the product has dried. They are epoxy resin molds that allow for quick drying of epoxy resin casts, with a high heat degree that can withstand temperatures between approximately 200 to 300 degrees in a hot environment. Our silicone molds are reusable and not disposable resin molds. Epoxy resin molds can be used in many different fields and can create variations in various sectors depending on your imagination.
Usage: Pour 2 parts resin to 1 part hardener into a container, and slowly stir until there are no air bubbles left. Stir the mixture in a right-to-left, left-to-right, and bottom-to-top direction for a thorough mixing for about 10-15 minutes. During mixing,

the stirring stick should touch the bottom and sides of the container to ensure a homogeneous mixture.
Then, let the mixture rest for 5 minutes, pour it into the mold, and let it dry. It can be touched by hand after about 6 hours. It fully hardens within 24 hours.
It becomes glass-like in 48 hours.

Important notice:

The general lifespan of the mold is usually 10, while in some model molds, it can be 20-25. Taking good care of your mold and following proper usage and cleaning procedures can extend its lifespan. We recommend using mold release spray, as it helps maintain the mold's shine and ensures longer lifespan. Non-alcohol-based wet wipes are the most effective in cleaning epoxy liquids. Never clean silicone molds with alcohol or solvent-based products, and be careful not to touch the mold with your fingers.