Epoxy Resin Mold Necklace Keychain Heart Friendship - 52 mm
Epoxy resin silicone injection molds are heat-resistant and easy to remove, allowing the resin epoxy castings to be easily removed after drying, with a high heat degree that enables rapid drying of products, ranging from an average of 200 to 300 degrees in a hot environment where it can be maintained. Also, our silicone molds are reusable and not for one-time use only resin molds. Resin epoxy molds, which can be used in many areas, can create differences in many sectors depending on your imagination.
Usage: Pour 2 parts resin to 1 part hardener into a container and slowly mix until there are no air bubbles left. Mix thoroughly for 10 - 15 minutes by stirring from right to left, left to right, and bottom to top. During mixing, the mixing stick should touch the bottom and sides of the container to provide a homogeneous mixture. Then, let the mixture rest for 5 minutes and pour it into the mold to dry. It becomes touchable after about 6 hours and completely hardens within 24 hours. It takes on a glassy appearance within 48 hours.
Color: Transparent
-
Important notice:
- The general lifespan of the mold is 10 times, but in some of our model molds, it can be between 20-25 times.
- By taking good care of your mold and following proper usage and cleaning procedures, you can extend its lifespan.
- We recommend using mold release spray or wax varnish to maintain the mold's shine and ensure a longer lifespan.
- Non-alcohol-based wet wipes are the most effective in cleaning epoxy liquids and residues.
- Avoid cleaning silicone molds with alcohol or solvent-based products, and be careful not to touch the mold with your fingers.
@CUSTOMER_NAME@
@AUTHOR_PROFILE@ @COMMENT_ISO_COUNTRY@@COMMENT_TITLE@
@COMMENT_COMMENT@