Resin Epoxy Coaster Mold - Wavy - Code:57

Epoxy Resin Mold Coaster 7.3 x 9 cm - Wavy

Epoxy resin silicone injection molds are heat resistant and easy to release, meaning they can be removed from the product after it has dried. These molds can withstand high temperatures, approximately between 200 and 300 degrees, in a hot environment, allowing for quick drying of resin epoxy pours. Our silicone molds are reusable and not for one-time use only. Depending on your imagination, epoxy resin molds can create differences in many sectors. Currently, we have more than 180 models of epoxy resin molds in Turkey.

Instructions: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and bottom to top for 2-3 minutes. A homogeneous mixture should be achieved by touching the bottom and sides of the container with the mixing stick during mixing. Let the mixture rest for 5 minutes, then pour it into the mold and let it dry. It becomes touchable in about 6 hours and completely hardens within 12 hours. It takes on a scratch-resistant glass-like appearance in 48 hours. Color: Transparent

Product Code: GJ131-02

Important note:

• The general lifespan of molds is usually around 10 uses, some models can be used 20-25 times.
• By taking good care of your mold and following proper usage and cleaning procedures, you can extend its lifespan.
• We recommend using mold release spray or wax varnish to maintain mold shine and ensure long-term use.
• Non-alcohol-based wet wipes are the most effective for cleaning epoxy liquids.
• Avoid cleaning silicone molds with alcohol or solvent-based products and refrain from touching the mold with your fingers.