Epoxy Resin Mold - Rectangular with Holes - E18

Epoxy Resin Mold-Holed Rectangle - 35 x 14.5 x 7 mm 4cm

• Epoxy resin silicone injection molds are heat resistant and easy to release, meaning they can be removed from the resin epoxy castings after they have dried, maintaining a high heat resistance of approximately 200 to 300 degrees in a hot environment, allowing for rapid curing of the resin epoxy.

• Our silicone molds are reusable, not for one-time use only resin molds. Epoxy resin molds can be used in many different fields and can create variations in various sectors depending on your imagination.

• Usage: Pour 2 parts resin and 1 part hardener into a container, mix slowly until no air bubbles remain. Mix thoroughly for 10 - 15 minutes in a back and forth, left to right, and bottom to top motion. During mixing, the mixing stick should touch the bottom and sides of the container to ensure a homogeneous mixture. Then let the mixture rest for 5 minutes, pour it into the mold, and let it dry. It can be touched by hand after approximately 6 hours. It will fully harden within 24 hours and achieve a glass-like state within 48 hours.

• Color: Transparent

• • Important note:

    • The general lifespan of the mold is 10 uses, some of our model molds can be used up to 20-25 times.
    • Taking good care of your mold and following proper usage and cleaning procedures can help extend its lifespan.
    • We recommend using mold release spray, as it preserves the mold's shine and ensures a longer lifespan.
    • Non-alcohol-based wet wipes are the most effective in cleaning epoxy liquids.
    • Avoid cleaning silicone molds with alcohol or solvent-based products, and make sure not to touch the mold with your fingers.