Heart Holographic Light and Shadow Epoxy Resin Mold - Code: 518

Heart Holographic Light and Shadow Epoxy Resin Mold - Code:518

Mold Size:

Single Heart: 3.4 x 3.9 cm

Complete Mold Size: 4.8 x 7.4 cm

Resin epoxy silicone injection molds are heat-resistant and easy-to-release molds that can withstand temperatures between 200 to 300 degrees Celsius, allowing for quick curing of resin epoxy casts that can be removed after the product has dried. Our silicone molds are reusable and not for one-time use. With over 600 resin epoxy mold models available in Turkey, these molds can create differences in various sectors based on your imagination.

Usage: Pour 2 parts resin to 1 part hardener into a container and slowly mix until no air bubbles remain. Mix thoroughly for 2-3 minutes from right to left, left to right, and bottom to top. The mixing rod should create a homogeneous mixture touching the bottom and sides of the container. Let the mixture rest for 5 minutes, then pour it into the mold and let it dry. It becomes touchable after about 6 hours and fully hardens within 12 hours. It achieves a scratch-resistant glass-like finish in 48 hours.

Product Code:

Important Notice:

• The general lifespan of molds is around 10 uses, some models can last between 20-25 uses.
• Taking good care of your mold and following proper usage and cleaning procedures can extend its lifespan.
• We recommend using mold release spray or wax varnish to maintain mold shine and ensure long-term use.
• Non-alcohol-based wet wipes are effective in cleaning epoxy residues.
• Do not clean silicone molds with alcohol or solvent-based products, and avoid touching the mold interior with your fingers.