Epoxy Resin Mold Domestic Product 10*10 CM Set of 4 Coasters - CB7

Epoxy Resin Mold 10*10 CM Set of 4 Coasters

• Epoxy resin silicone injection molds are heat resistant and easy to release, allowing for quick drying of resin epoxy pours. They can withstand high temperatures, typically between 200 to 300 degrees Celsius, in a hot environment after the product has dried.

• Our silicone molds are reusable and not for one-time use only. Epoxy resin molds can be used in many different fields, creating variations based on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly for 10-15 minutes in a back-and-forth, side-to-side, and bottom-to-top motion. The mixing rod should touch the bottom and sides of the container to ensure a homogeneous mixture. Let the mixture rest for 5 minutes, then pour it into the mold and let it dry. It becomes touchable after about 6 hours and fully hardens within 24 hours. It achieves a glass-like state within 48 hours.

• • Important Notice:

    • The general lifespan of a mold is around 10 uses, but some models can last up to 20-25 uses.
    • Taking good care of your mold and following proper usage and cleaning procedures can extend its lifespan.
    • We recommend using mold release spray, wax, or varnish to maintain mold shine and prolong its lifespan.
    • Non-alcohol-based wet wipes are the most effective for cleaning epoxy residues.
    • Avoid cleaning silicone molds with alcohol or solvent-based products, and be careful not to touch the mold surface with your fingers.