Droplet Necklace and Earring Epoxy Mold - Code: 72

Drop Necklace and Earring Epoxy Mold - 5.6 x 3.6 x 2.1 cm

Epoxy resin silicone injection molds are heat-resistant and easy-to-release molds that can withstand high temperatures, approximately between 200 and 300 degrees Celsius, in a hot environment, allowing rapid curing of resin epoxy casts that can be removed after the product has dried. Additionally, our silicone molds are reusable and not for one-time use only resin molds. Epoxy resin molds can create variations in many sectors depending on your imagination. Currently, in Turkey, we have more than 600 models of resin epoxy molds available.

Usage: Pour 2 parts resin and 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and from bottom to top for 2-3 minutes. During mixing, the mixing stick should touch the bottom and sides of the container to provide a homogeneous mixture. Then let the mixture rest for 5 minutes, pour it into the mold, and let it dry. It can be touched by hand after approximately 6 hours. It will completely harden within 12 hours and obtain a scratch-resistant, glass-like finish within 48 hours. Color: Transparent

Product Code: GJ042

Important Warning:

• The general lifespan of the mold is usually 10 uses, while some of our model molds can be used up to 20-25 times.
• Taking good care of your mold and following proper usage and cleaning procedures can help you prolong its lifespan.
• We recommend using mold release spray or wax varnish to maintain the shine of the mold and ensure a longer lifespan.
• For cleaning, non-alcohol-based wet wipes are the most effective for removing epoxy residues.
• Avoid cleaning silicone molds with alcohol or solvent-based products and refrain from touching the mold with your fingers.