Rectangular Glass Bottom Invitation Magnet 12x8 cm Epoxy Resin Silicone Mold-Code:1013

Rectangle Glass Bottom Invitation Magnet 12x8 cm Epoxy Resin Silicone Mold Resin epoxy silicone injection molds are heat resistant and easily removable molds that allow resin epoxy castings to dry quickly at a high temperature range of approximately 200 to 300 degrees in a hot environment. Our silicone molds are reusable, not for one-time use resin molds. Resin epoxy molds can create differences in many sectors depending on your imagination. Usage: Mix 2 parts resin with 1 part hardener in a container and stir slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and bottom to top for 10-15 minutes. The mixing stick should touch the bottom and sides of the container to ensure a homogeneous mixture. Then, let the mixture sit for 5 minutes, pour it into the mold, and let it dry. It becomes touchable after about 6 hours and completely hardens within 24 hours. It reaches a glass-like state within 48 hours. Color: Transparent Important Note: The general lifespan of the mold is 10 uses, while some of our models can be used up to 20-25 times. Taking good care of your mold, along with proper usage and cleaning practices, can prolong its lifespan. We recommend using mold release spray or wax varnish to maintain the mold's shine and ensure a longer lifespan. Alcohol-based wet wipes are the most effective in cleaning epoxy liquids. Do not clean silicone molds with alcohol or solvent-based products, and avoid touching the mold with your fingers.