HELLO KITTY RESIN EPOXY MOLD - H3

Hello Kitty Resin Epoxy Mold

• Resin epoxy silicone injection molds are heat resistant and easy to release, meaning they can be removed from the resin epoxy castings after they have dried. They are resin epoxy molds that can withstand high temperatures, typically between 200 and 300 degrees Celsius, in a hot environment to facilitate rapid drying of resin epoxy castings.

• Our silicone molds are reusable and not disposable resin molds. Resin epoxy molds that can be used in many areas can create variations in many sectors depending on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Stir the mixture thoroughly from right to left, left to right, and from bottom to top for 10 - 15 minutes. During mixing, the mixing stick should create a homogeneous mixture that touches the bottom and sides of the container.
  Then let the mixture rest for 5 minutes, pour it into the mold, and let it dry. It can be touched by hand after about 6 hours. It will completely harden within 24 hours.
  It will reach a glass-like state within 48 hours.

• • Important Warning:

    • The general lifespan of the mold is usually 10 uses, but in some model molds, it can be 20-25 uses.
    • Taking good care of your mold and following proper usage and cleaning procedures can extend its lifespan.
    • We recommend using mold release spray, as it maintains the mold's shine and prolongs its lifespan.
    • Non-alcohol-based wet wipes are the most effective material for cleaning epoxy liquids.
    • Avoid cleaning silicone molds with alcohol or solvent-based products, and be careful not to touch the mold with your fingers.