12.5cm - Flower Pattern Coaster Mold - Code: SN1243

• 12.5cm - Flower Pattern Coaster Mold

Mold diameter: 12.5cm

Depth: 8 mm

Measurements may vary slightly.

• Resin epoxy silicone injection molds are heat-resistant and easy-to-release molds that can withstand heat, allowing quick curing of resin epoxy pours in a hot environment ranging from approximately 200 to 300 degrees, and can be easily removed once the product has dried.

• Our silicone molds are reusable and not for one-time use. Resin epoxy molds can be used in various fields and can create differences in many sectors depending on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Stir the mixture thoroughly for 10-15 minutes in a back-and-forth, left-to-right, and bottom-to-top motion. The stirring rod should touch the bottom and sides of the container to achieve a homogeneous mixture. Let the mixture rest for 5 minutes, then pour into the mold and let it dry. It will be touch-dry in about 6 hours and fully cured within 24 hours, reaching a glass-like state in 48 hours.

• Color: Transparent