Covered Candy Dish Decorative Concrete Mold - Code: 434

Decorative Concrete Mold with Lid - Code: 434

Mold Size: Top 6.5 cm - Bottom 3 cm in height / 9 cm in width

Product Size: 9 cm in Height 8 cm in Width


There may be slight variations in measurements.

This Model is Suitable for Epoxy and Concrete Casting.

Epoxy resin silicone injection molds are heat resistant and easily separable, meaning they can be removed from the product after it has dried. They are epoxy resin molds that can withstand high temperatures, around 200 to 300 degrees Celsius, allowing for quick drying of resin epoxy castings. Additionally, our silicone molds are reusable and not for one-time use only. Our epoxy resin molds can be used in many different fields and can create variations in many sectors depending on your imagination. Currently, we have more than 600 models of epoxy resin molds in Turkey.

Usage: Pour 2 parts resin and 1 part hardener into a container and mix slowly until there are no air bubbles left. Mix right to left, left to right, and up and down for 2-3 minutes. Homogeneous mixture should be achieved by touching the mixing rod to the bottom and sides of the container during mixing. Let the mixture rest for 5 minutes, then pour it into the mold and let it dry. It becomes touchable by hand after about 6 hours and completely hardens within 12 hours. It acquires a scratch-resistant glass-like appearance in 48 hours. Color: Transparent

Product Code: GJ048

Important Notice:

• The general lifespan of the mold is typically 10 times, but for some models, it can be between 20-25 times.
• Taking good care of your mold and following proper usage and cleaning procedures can help prolong its lifespan.
• We recommend using mold release spray, as it maintains the mold's glossiness and ensures a longer lifespan.
• Non-alcohol-based wet wipes are the most effective for cleaning and removing epoxy liquids.
• Avoid cleaning silicone molds with alcohol or solvent-based products, and be careful not to touch the mold with your fingers.