Heart Resin Epoxy Mold - b17

Heart Resin Epoxy Mold - 839 - B17

• Resin epoxy silicone injection molds are heat resistant and easy to release, meaning they can be removed after the product has dried. They are resin epoxy molds that can maintain a high heat degree between approximately 200 to 300 degrees in a hot environment, allowing for quick drying of resin epoxy pours.

• Our silicone molds are reusable and not for one-time use only. Resin epoxy molds, which can be used in many areas, can create differences in various sectors depending on your imagination.

• Instructions for Use: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and bottom to top for 10 - 15 minutes. During mixing, the mixing stick should touch the bottom and sides of the container to ensure a homogeneous mixture.
  Then let the mixture rest for 5 minutes, pour it into the mold, and leave it to dry.
  It becomes touchable by hand after about 6 hours. It fully hardens within 24 hours.
  It reaches a glass-like state in 48 hours.

• • Important Warning:

    • The typical lifespan of the mold is generally 10 uses, but some of our model molds can be used up to 20-25 times.
    • Taking good care of your mold and following proper usage and cleaning procedures can help you prolong its lifespan.
    • We recommend using mold release spray, as it maintains the mold's glossiness and ensures a longer lifespan.
    • Non-alcohol-based wet wipes are the most effective material for cleaning epoxy liquids.
    • Absolutely do not clean silicone molds with alcohol or solvent-based products, and avoid touching the mold with your fingers.