4-eyed glass epoxy paint pouring silicone mold: 1034

5-Eyed Epoxy Paint Casting Silicone Mold 1034 85 gr

Important warning:
The general lifespan of molds is usually around 10 but in some of our models, it is between 20-25.
Taking good care of your mold and following proper usage and cleaning procedures can extend its lifespan.
We recommend using mold release spray, as this spray or wax varnish preserves the shine of the mold and ensures a longer lifespan.
Non-alcohol-based wet wipes are the most effective material for cleaning epoxy liquids and removing residue from silicone molds.
Never clean silicone molds with alcohol or solvent-based products, and try to avoid touching the mold with your fingers.

Epoxy resin silicone injection molds are heat-resistant and easily separable, meaning they can be removed from the product after it has dried. These molds can withstand high temperatures ranging from 200 to 300 degrees in a hot environment, allowing for quick drying of resin epoxy castings.

Our silicone molds are reusable and not for one-time use only. Epoxy resin molds can be used in various fields and can create differences in many sectors depending on your imagination.
Usage: Pour 2 measures of resin and 1 measure of hardener into a container, and mix slowly until no air bubbles remain. During mixing, stir from right to left, left to right, and bottom to top for 10-15 minutes to ensure a homogeneous mixture that touches the bottom and sides of the container.
Afterwards, let the mixture rest for 5 minutes, then pour it into the mold and let it dry. It will become touchable after approximately 6 hours and completely hardened within 24 hours. It will reach a glass-like state within 48 hours.