5 pieces of 6cm - 10-pack Round Magnet Mold

• 5 Pieces 6cm - 10-Piece Round Magnet Mold 7cm - 10-Piece Round Magnet Mold

Round diameter: 6 cm

There May Be Slight Differences in Measurements.

• Resin epoxy silicone injection molds are heat resistant and easy to release, meaning they can be removed from the resin epoxy casts after they have dried. They are resin epoxy molds that enable rapid drying in resin epoxy casts, can withstand high temperatures between approximately 200 to 300 degrees Celsius in a hot environment.

• Our silicone molds are reusable and not for one-time use only resin molds. Resin epoxy molds can be used in many different fields and can create variations in many sectors depending on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and from bottom to top for 10 - 15 minutes. During mixing, the mixing stick should touch the bottom and sides of the container to ensure a homogeneous mixture. Allow the mixture to rest for 5 minutes, then pour into the mold and let it dry. It will be touchable after approximately 6 hours and fully hardened within 24 hours. It will achieve a glass-like state in 48 hours.

• Color: Transparent