Pomegranate Glass Coaster Mold - Hobby Silicone Mold - Code: SN1234

• Glass with Pomegranate Design Mold

Mold Size

Height: 10 cm

Width: 10 cm

Measurements may slightly vary.

Resin epoxy silicone injection molds are heat-resistant and easy-to-release molds that can withstand an average temperature of 200 to 300 degrees Celsius, allowing for quick drying of resin epoxy casts.

Our silicone molds are reusable, not for one-time use resin molds. Resin epoxy molds can create variations in many sectors depending on your imagination.

Usage: Pour 2 parts resin to 1 part hardener into a container and stir slowly until no air bubbles remain. Stir the mixture thoroughly for 10-15 minutes from right to left, left to right, and bottom to top. During mixing, the mixing stick should touch the bottom and sides of the container to achieve a homogeneous mixture. Let the mixture rest for 5 minutes and then pour it into the mold to dry. It becomes touchable by hand after about 6 hours and completely hardens within 24 hours. It achieves a glass-like state in 48 hours.