Snowflake Holographic Silicone Bookmark - Hobby Silicone Mold - Code:456

• Snowflake Holographic Silicone Bookmark
• Pattern Size
• Height: 14 cm
• Width: 17.4 cm
• Weight: 130 grams

There may be slight differences in measurements.

• Resin epoxy silicone injection molds are heat resistant and easy to detach, meaning they can be removed after the product has dried in resin epoxy pourings, allowing for quick curing in a hot environment with an average temperature range of 200 to 300 degrees Celsius.

• Our silicone molds are reusable and non-disposable resin molds. Epoxy resin molds, which can be used in many areas, can create variations in many sectors depending on your imagination.

• Usage: Pour 2 measures of resin and 1 measure of hardener into a container and mix slowly until there are no air bubbles left. Mix thoroughly for 10-15 minutes by stirring from right to left, left to right, and bottom to top. During mixing,
  The stirring rod should be touched to the bottom and edges of the container to ensure a homogeneous mixture.
  Then, the mixture is left to rest for 5 minutes and poured into a mold to dry.
  It can be touched by hand in about 6 hours. It will fully harden within 24 hours.
  It takes on a glassy state once every 48 hours.

• Color: Transparent