Multiple Small Epoxy Mold - Jewelry Mold 1 - CK4 - 834

Epoxy Resin Mold - Multi Jewelry Mold - Small - 10 x 7 cm

• Epoxy resin silicone injection molds are heat resistant and easy to release, meaning they can be removed from the product after it has dried, maintaining a high temperature of approximately 200 to 300 degrees in a hot environment, allowing for quick drying of resin epoxy pours.

• Our silicone molds are reusable, not for one-time use resin molds. Epoxy resin molds can be used in many fields and can create differences in various sectors depending on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and from bottom to top for 10 - 15 minutes. During mixing, the mixing stick should create a homogeneous mixture touching the bottom and sides of the container.
  Then let the mixture rest for 5 minutes, pour it into the mold, and let it dry. After about 6 hours, it can be touched by hand. It will fully harden within 24 hours and turn into a glass-like state in 48 hours.

• • Important warning:

    • The general lifespan of the mold is usually 10 uses, while some of our model molds can be used between 20-25 times.
    • Taking good care of your mold and following proper usage and cleaning procedures can extend its lifespan.
    • We recommend using mold release spray, as it maintains the mold's shine and prolongs its lifespan. Non-alcohol-based wet wipes are the most effective for cleaning epoxy liquids.
    • Avoid cleaning silicone molds with alcohol or solvent-based products and make sure not to touch the mold with your fingers.