6cm - 10-piece Round Magnet Set

• 6cm - Set of 10 Round Magnet Mold
  7cm - Set of 10 Round Magnet Mold

Diameter: 6 cm

There May Be Slight Variations in Measurements.

• Resin epoxy silicone injection molds are heat resistant and easily removable molds that allow quick drying of resin epoxy castings, capable of withstanding temperatures between approximately 200 to 300 degrees Celsius in a hot environment.

• Our silicone molds are reusable molds that can be used multiple times and are not for one-time use only. Resin epoxy molds can create variations in many sectors depending on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly for 10-15 minutes by stirring from right to left, left to right, and bottom to top. During mixing, the mixing stick should touch the bottom and sides of the container to ensure a homogeneous mixture. Let the mixture rest for 5 minutes, then pour it into the mold and let it dry. It becomes touchable in about 6 hours and fully hardens within 24 hours. It reaches a glass-like state in 48 hours.

• Color: Transparent