7cm - Pack of 10 Round Magnets

• 7cm - Set of 10 Round Magnet Molds

Round diameter: 7 cm

There May Be Slight Variations in Dimensions.

• Resin epoxy silicone injection molds are heat-resistant and easy-to-remove molds that can withstand temperatures between approximately 200 to 300 degrees Celsius, allowing for quick drying of resin epoxy casts after drying.

• Our silicone molds are reusable and not for one-time use resin molds. Resin epoxy molds can be used in various fields, creating differences in many sectors depending on your imagination.

• Usage: Pour 2 parts resin to 1 part hardener into a container and mix slowly until no air bubbles remain. Mix thoroughly from right to left, left to right, and bottom to top for 10-15 minutes. During mixing, the mixing stick should touch the bottom and sides of the container to ensure a homogeneous mixture. Allow the mixture to rest for 5 minutes, then pour it into the mold and let it dry. It will be touchable in about 6 hours and fully hardened within 24 hours. It will reach a glass-like state in 48 hours.

• Color: Transparent